VCF 9.x Bringup Series – Part1: Preparing ESX Hosts
This is part 1 of a series of blog posts where I will walk you through all the steps needed to prepare your ESX hosts as part of bringing up…
-
-
VCF 9.x Bringup Series – Part4: VCF Fleet Deployment using the VCF Installer
In this part of the series, we will proceed with the VCF fleet deployment via the VCF Installer appliance. The VCF Installer appliance replaces the Cloud Builder appliance used in…
-
MTU Change on a vSphere Environment
A jumbo frame is an Ethernet frame with a payload greater than the standard maximum transmission unit (MTU) of 1,500 bytes. Jumbo frames allow ESXi to send larger frames out onto the physical network . Jumbo Frames can…
-
Building a Multi-NIC VCF 4 Workload Domain using API | LAB2PROD
September 29, 2020 Building a Multi-NIC VCF 4 Workload Domain using API | LAB2PROD Using API to create a VMware Cloud Foundation (VCF) multi-nic workload domain In this article we…
-
Isolated vCenter 6.5 HA nodes “Failed to ssh connect peer node x.y.z.w”
Introduction: Prior to vSphere 6.5, Windows Failover Cluster and Fault Tolerance (after it was improved to support 4 vCPU in vSphere 6.0) were two applicable methods to protect vCenter. These…
-
NSX-T Transport VLANs and Inter TEP Communication | LAB2PROD
November 15, 2020 NSX-T Transport VLANs and Inter TEP Communication | LAB2PROD Inter TEP Communication, Sharing Transport VLANs: Unpacking One of The Latest Features In NSX-T 3.1 This post will…
-
DELL PowerEdge ESXi Hosts: LLDP Not Working With Intel X710 10GB Cards
Recently I was engaged with a full vSphere migration for one of our customers (both hardware and software). We faced an issue getting Link Layer Discovery Protocol (LLDP) to work…
-
Migration from Collapsed to Dedicated NSX Edge Cluster
In a recent PSO VMware NSX engagement with one of our customers, and as their new hardware arrived, they decided to make a migration of ESG edges and DLR control…
-
Step-by-Step: Deploy VMware NSX-T 2.4.1 Manager
I have been designing and deploying NSX-v solutions as part of my PSO role for the past 3 years. Aside with that, I decided to start my journey towards NSX-T…
-
NSX-T 2.4.1: Configure NSX-T Manager Cluster
NSX-T 2.4.x manager is an appliance with 3 built-in roles: policy manager, manager, and controller. The management plane contains the policy and the manager roles. The central control plane includes…
-
NSX-T: Migrate VMKernel Ports from VSS/VDS to N-VDS
It has been a while I didn’t write any blog due to my short time handling multiple PSO projects with a lot of traveling. Today I am going to share…
